Wayne-Dalton Quantum 3000 Series Owner Installation And User Manual

2Read These Important Safety Rules Before ProceedingIMPORTANT INSTALLATION INSTRUCTIONSWARNING: To reduce the risk of severe injury of death:READ AND FOLLOW ALL INSTALLATION IN-STRUCTIONS.Install only on a properly balanced garage door.An improperly balanced door could cause severeinjury. Have a qualified service person make re-pairs to cables, spring assemblies and otherhardware before installing opener.To reduce the risk of injury to persons, use thisoperator only with sectional overhead doors.Fiberglass, aluminum and steel doors must be re-inforced to prevent damage to the door. Checkwith your garage door manufacturer for their rec-ommendations.Remove all ropes and remove or make inoperativeall locks connected to the garage door before in-stalling opener.Do not use sensitivity adjustments to compensatefor a poorly operating door. This will interferewith the proper operation of the safety reversemechanism and may damage the door.Locate control button: within sight of door, at aminimum height of 5 feet, so small children can-not reach it, and away from all moving parts of thedoor.If possible, install door opener 7 feet or moreabove floor. Mount the emergency release knob 6feet above the floor.Do not connect opener to source of power untilinstructed to do so.Installation and wiring must comply with localbuilding and electrical codes. Connect the powercord to a properly grounded outlet. Do not re-move round ground pin from power cord.Install entrapment warning label next to controlbutton in a prominent location, such as the insideof the garage door, or as instructed in the installa-tion instructions. If label adhesive will not adhereto the surface, secure the label by additional me-chanical means such as staples, nails or screws.If necessary, use an intermediate mounting sur-face, such as plywood, cut to the appropriate size.Install Emergency Release tag to the emergencyred cord.After installing opener, the door must reversewhen it contacts a 1 inch high solid test object onthe floor.Open door must not close and closing door mustopen if photoelectric system in obstructed by 6” x12” object, using test procedure described in Step30.Do not wear rings, watches or loose clothingwhen installing or servicing a garage door sys-tem. Use a sturdy, non-metallic step ladder.AFTER INSTALLATION IS COMPLETE, FASTEN THIS MANUAL NEAR GARAGE DOOR.PERFORM PERIODIC SAFETY CHECKS, MAINTENANCE AND ADJUSTMENTS, AS RECOMMENDED.NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener-ates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-ference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increasethe separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiveris connected. Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this unit not ex-pressly approved by Wayne-Dalton Corp. could void the user’s authority to operate the equipment.FCC Regulatory Information: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that maycause undesired operation.IC Regulatory Information: This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment Regula-tions. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must ac-cept any interference received, including interference that may cause undesired operation.This symbol indicates caution and appears throughout this instructionmanual. This garage door opener is designed and tested to offer reasona-bly safe operation if installation is followed in strict accordance with thesesafety instructions. Failure to comply with these instructions may result inserious personal injury or property damage.All manuals and user guides at all-guides.com