8Step 6: Mounting Door BracketFiberglass, aluminum and steel doors mustbe reinforced to prevent damage to thedoor. Check with your garage door manu-facturer for their recommendations.Reinforce light weight doors, as illustrated.For wood doors, mount door bracket, using two 1/4”-20 x2” carriage bolts and 1/4” nuts supplied, on center line ofdoor with middle hole in line with top rollers.For metal doors, mount door bracket, using two 1/4”-20 x1/2” self drilling screws supplied, on center line of doorwith middle hole in line with top rollers.Step 7: Installing LightRemove diffuser cover by pressing on both sides of the bottom of thelighting cover at the junction of the housing, releasing the locking tabs,and pulling forward. Screw a 60 Watt bulb (60 Watt Maximum) intosocket. For maximum bulb life, “rough service” bulbs are recom-mended. Align top and bottom tabs on cover to Motor Power Head Unitand push straight on until cover locks into place.Note: light turns on automatically when door is activated and a 4 minutetime delay circuit automatically turns light off, allowing ample time to en-ter the house. A fully open door with light blinking indicates an obstruc-tion or problems with external safety sensors during close travel. Seetrouble shooting section for further details.Step 8: Installing Wired Wall Station (if included)Install all wall controls out of thereach of children and in a locationwhere the door can be seen beforeactivating. Do not mount wall con-trols near or next to garage door.Wired Wall Station: Wire the garage door opener wallstation using bell wire (low voltage electrical wire) con-nected to COM and P.B. on vertical screw terminalstrips, as illustrated.Locate push button adjacent to service entrance door ata minimum height of 5 ft., and at least 5 ft. away fromgarage door; (see illustration in Step 10); additionalwired wall stations may also be installed in accordancewith these instructions.All manuals and user guides at all-guides.com