Manuals database logo
manualsdatabase
Your AI-powered manual search engine

Wearable Life Science ANTELOPE.TECHWEAR User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Contents
  1. ANTELOPE.TECHWEAR
  2. CONTACT CUSTOMER CARE
  3. Table Of Contents
  4. INTRODUCTION
  5. INDICATIONS
  6. CONTRAINDICATIONS
  7. SCOPE OF SUPPLY
  8. ANTELOPE.TANK-TOP
  9. ANTELOPE.APP
  10. INSTRUCTIONS FOR USE
  11. Putting on the ANTELOPE.CALF-GUARDS
  12. Starting the Stimulation
  13. Battery status
  14. TROUBLE SHOOTING
  15. SAFETY INSTRUCTIONS
  16. GUARANTEE AND WARRANTY
  17. TECHNICAL SPECIFICATIONS
Wearable Life Science ANTELOPE.TECHWEAR User Manual Manual pdf 12 page image
12Wearable Life Science GmbH8.3 Putting on the ANTELOPE.CALF-GUARDS1. Open the zipper on each CALF-GUARD.2. Put on the CALF-GUARDS and make sure that the electrodes lie flaton your skin without folds or wrinkles.3. Close the zippers.8.3.1 Connecting the ANTELOPE.CALF-GUARDS and the ANTE-LOPE.2C-BOOSTERDANGERV DO NOT CONNECT THE ANTELOPE.CALF-GUARDS WITH ANTE-LOPE.2C-BOOSTER IF THE BOOSTER IS TURNED ON.1. Connect the magnetic button ending of the external cable to themagnetic buttons on the textile. Only one cable pair should be usedto connect both CALF-GUARDS.2. Connect the jack plugs of the external cables to the jack plug inputat the bottom of the 2C-BOOSTER.NOTEBe sure to observe which channel (I or II) the external cables are connect-ed to.8.4 Switching the ANTELOPE.2C-BOOSTER and ANTELOPE.8C BOOST-ER ON/OFF• On: Press and hold the [+]-button for three seconds.• Off: Press and hold the [-]-button for three seconds.8.5 Connecting the ANTELOPE.2C-BOOSTER andANTELOPE.8C-BOOSTER to the ANTELOPE.APP via BluetoothNOTEThe ANTELOPE.APP must first be downloaded via the App Store or GooglePlay Store before connecting.1. Hold the [+] button on the BOOSTER until the blue shining LED be-gins to flash. This indicates the BOOSTER is searching for a compat-ible device via Bluetooth.2. Switch the Bluetooth ON from your compatible device3. Open the ANTELOPE.APP on your device and select the “connect”tab. Your Booster appears on this page. Tap on the Booster to con-nect and select the options in the fields to continue.NOTE• After switching on the BOOSTER and before connecting to a Blue-tooth device, the BOOSTER will display a constant green LED.• After connecting to the APP via Bluetooth, the LED will change to aconstant blue light.DANGERIf the connection to a Bluetooth device is interrupted for several minutes,the BOOSTER DOES NOT switch off automatically. If a connection betweena Bluetooth device and the BOOSTER is interrupted, immediately discon-nect the connection between BOOSTER and Baseplate. (see 8.7.1)
/ 19
This manual is suitable for:
ANTELOPE.TECHWEAR
Manuals database logo
manualsdatabase
Your AI-powered manual search engine