Wearable Life Science ANTELOPE.TECHWEAR User Manual
                   | |
Contents
| 
13Wearable Life Science GmbH8.6 Starting the StimulationNOTEStimulation can only be started from the ANTELOPE.APP. App and BOOST-ER must be connected before.1. Tap the EMS tab of the ANTELOPE.APP and select a program.NOTE The duration of each program can be adjusted.2. Tap the “start” button at the bottom of the screen to begin stimula-tion.8.7 Regulating Stimulation• Once the stimulation has been started it can be regulated using theANTELOPE.APP and/or directly from the ANTELOPE.BOOSTER.• Pressing the [+] on the EMS tab of the ANTELOPE.APP OR on theBOOSTER, will increase the intensity by one unit on all channels.• Pressing the [-] on the EMS tab of the ANTELOPE.APP OR on theBOOSTER, will reduce the intensity by one unit on all channels.DANGERIf stimulation cannot be felt at an intensity of 25%, SWITCH OFF the BOOST-ER and APPLY ANTELOPE. SPRAY directly to the electrodes in the textile.Then restart the ANTELOPE.APP and make sure that all intensity levels areset to 0. Once this process is completed, restart using your ANTELOPE.TECHWEAR according to the instructions in this manual. (see 8.1).NOTETapping the muscle groups on the EMS tab of ANTELOPE.APP will enableindividual regulation of specific muscle groups.8.7.1 Ending the StimulationStimulation can be ended by:• Pressing the [-] button on the BOOSTER for 3 Seconds.• Pressing “pause” on the ANTELOPE.APP.ORDANGER• Directly detaching the BOOSTER from the Baseplate or External Ca-bles by pulling with force.8.8 Using the ANTELOPE.2C-BOOSTER and ANTELOPE.8C-BOOSTERNOTEPlease fully charge the ANTELOPE.8C-BOOSTER before initial use. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine