Wood Stone DESIGNER SERIES 6348 WS-DS1-4048 Installation And Operation Manual

Designer Series 1 w/ Broiler OptionInstallation and Operation ManualAn ongoing program of product improvement may require us to changespecifications without notice� Designer Series-1 w/ Broiler Option,Revised November 2014. Doc no: M0078.00info@woodstone-corp.com or visit woodstone-corp.comWood Stone Corporation1801 W. Bakerview Rd.Bellingham, WA 98226 USAToll Free 800.988.8103Tel 360.650.1111Fax 360.650.116611UTILITY CONNECTIONSELECTRICAL CONNECTIONSA junction box is provided on one side of the oven (specified at time of order) towards the back of the oven� The incoming poweris connected to oven at this junction box� Check the equipment data plate to verify proper voltage before connecting the oven� Ifneeded, the location of the junction box may be easily relocated to the opposite side of the oven by the installer�This appliance must be electrically grounded in accordance with local code, or in the absence of local code, with thenational electrical code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.2, as applicable. An electrical diagram isprovided inside the oven control box, and on the transformer box beneath the oven as well, and at the end of this manual.GAS CONNECTIONConnect the incoming gas supply to the 3/4 inch FNPT gas inlet located on one side of the oven� A gas inlet is available on each sideof the oven� Both inlets are plugged at the factory� Remove the plug from the inlet to which the connection will be made� Verify thatthe unused inlet remains plugged� A 3/4 inch full-flow gas shut-off valve (supplied by others) must be installed on the gas supplynear the oven in such a way that it is readily accessible�UTILITY LOCATIONSUtility locations shown below as left-side configuration� Right-side configuration would mirror left-side configuration�ASSEMBLY -- CONNECTIONS