Wood Stone WS-GFT-31 Installation And Operation Manual

Also see for WS-GFT-31: Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation manual Installation and operation

Contents

11An ongoing program of product improvement m ay require u s to changespecications without notice. WS-GFT, Revised April 2015.Doc no: M0053.02info@woodstone-corp.com or visit woodstone-corp.comwood stone corporation1801 w. bakerview rd.bellingham, wa 98226 usatf. 800.988.8103t. 360.650.1111f. 360.650.1166Tandoor Installation and Operation ManualOPERATIONPILOT LIGHTING PROCEDURETurn the Temperature Control Knob on the top of the unit to the OFF position before attempting to light the pilot.1. Turn the Gas Control Knob on the safety valve to the PILOT position.2. Push down on the Gas Control Knob and light the pilot immediately by pressing the red button of the spark igniter. Pressthe igniter every 2 seconds until a pilot flame is established� Hold the Gas Control Knob down for one full minute after lightingthe pilot�3. Release the Gas Control Knob – the pilot flame should continue to burn. If the pilot flame does not remain lit, turn the gascontrol valve to the OFF position, wait 5 minutes, and then repeat the steps above�4. Once pilot is established, turn the Gas Control Knob on the safety valve (counterclockwise) from the PILOT to the ONposition. NOTE: failing to turn the Gas Control Knob to the full ON position will reduce the flow of gas and could result in poorignition of the main burner�5. Round/Square/Octagonal Tandoors: Use the Temperature Control Knob on top of the Tandoor to control the height ofthe cooking flame.Barrel models: Use the Temperature Control Knob on the Control Box at the front end of the oven to control the heightof the cooking flame.FIRST FIRINGThe first time the Tandoor is fired, the heat-up should be slow and steady� Hold the burner at avery low flame (Temperature Control Knob set at “1” on models that are marked) for at least 8hours with the lid on� Following this procedure will safely saturate the chamber with heat� You maynotice some small “crazing” cracks in the ceramic chamber after a few heat-ups and cool-downs�Don't be alarmed as this is normal and will not affect the longevity or performance of the Tandoor�First firing settingPlan viewTemperatureControl KnobFront viewSpark Igniter Button (Red)Drip/ Debris PanLidGas Control KnobTemperature Control KnobOPERATION

/ 13

Related manuals for Wood Stone WS-GFT-31