Treating simple errorsPRINCESS – Edition: 17.02.200576FIELD SERVICE MANUAL18 Steps to solve mechanical problemsIn case of a mechanical error the software tries to solve the problem itself. If this is not successful themechanism switches itself off. Then the display shows an error code (ref. to chapt. 7.3. page 64).The jukebox is then out of order.18.1 Treating simple errorsSwitch the jukebox off and on several times. (The software tries to solve the problem again.) No suc-cess ? Step to chapter 18.2.18.2 Treating simple errors by hand1. Switch off the jukebox2. Move the gripper by pressing against the motor as far as the CD can be taken out by hand.3. Take the CD out of the gripper.4. Insert the CD in the corresponding compartment.5. Switch on the jukebox, it will be run automatically:# Error elimination# Initializing phase# jukebox ok.6. No success ? Step to chapter 18.3.18.3 Set the mechanism to ‘0’ position1. Power OFF!2. Open the Jukebox.3. Open the mechanism housing, replace any CDs that may have been dropped.4. Move gripper to RH. 0-position.# Move, by pressing against the gripper motor, gripper holder of selection sledge so that LH.side of gripper holder aligns with RH. side of pressure disc holder.# If RH. position impossible:# Move gripper to the LH. 0-position, so that right edge of gripper holder aligns with LH sidepressure disc holder.5. Remove the left magazine. (to reach the gear).6. Position of the selection sledge.# The sledge has to be at least 1,3 ‘’ (3 cm) over the housing bottom. Therefore move thesledge up and down by hand using the toothed belt wheel on the top LH. side of gear group.7. Insert the left magazine.
