X Models Blade XL Operating Manual
                                           | |
Contents
| 
Nuova FULCRO Service13Finishing tail panelsTail panels support pins• Using a pair of pliers, bend a little bit the twotail connection pins in order to make themslightly diverging (see figure 25); this opera-tion will avoid the tail to slip out from its sup-ports during the flight;Fig.24: Bend the two pins.• using a sharp knife, remove the glue in ex-cess from the root of the pins (see figure25);Fig.25: Remove the glue in excess.Pushrods connections• Fully fasten the ball “GIUN” on the screw“VITE” (see figure 26);Fig.26: Fasten the ball on the screw.• screw the ball connector into the tail panelunit (see figure 27);• repeat the operation for the other tail panel;Fig.27: Fastening the group screw-ball.GIUN VITE |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine