X Models Blade XL Operating Manual
                                           | |
Contents
| 
Nuova FULCRO Service31Servo coversThe wing servo covers are made from the shapes “CARS”.From every shape, two covers can be made (left and right):• take the distance (1) from the external edgeof the servo housing and the servo horn(see figure 76);• take the dimensions (2 and 3) of the externalservo housing edges;Fig.76: Take the dimensions.• taking as reference the center of a bulge ofthe shape “CARS” (see figure 77), carry thetaken measure (1) from the external edge ofthe servo housing and the servo horn;• from that point, using a pencil, draw a rect-angle with the same dimensions (2 and 3) ofthe external housing edge taken before;Fig.77: Shape for two servo covers (left and right).• symmetrically, make the other servo cover from the other half of the shape;• repeat the procedure for the other shape in order to obtain the four servo covers required;• using a file, finish every cover fitting it to thecorresponding housing;• using some thin double adhesive tape, applythe inner covers (see figure 78).Note: the outer covers will be applied to the wing just af-ter the lateral model balancing that will be described lat-er.Fig.78: Servo cover in position.1 32132 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine