X Models Blade XL Operating Manual
                                           | |
Contents
| 
Nuova FULCRO Service373.2 Model balancingCGThe CG of the model must be placed at 83 ~ 88 mm from the wing leading edge at the wing root(see figure 86).Fig.85: CG position.Note: You may in a second time move it a little backwards if you feel (and if you are a real good pilot...).Checking and correcting the CG position• Mark with a piece of tape the CG position under the wing and hold the model with your fingers:the model must stay level;• remove or add lead to front until satisfied.Note: the model must be complete with all his part including the nose cover during the CG check.• once positioned the CG in the correct point, secure the lead used to balance, in the nose, so itcannot move again.Checking and correcting the lateral balance (both versions)Before to apply the outer servo covers, we recommend to check (and eventually correct) themodel lateral balancing.Checking• Lay the model on a flat hard surface;• try to keep the model flat rising the wing that is in touch with the ground;83 ~ 88 mm |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine