Xerox Nuvera® 100/120/144 EA Digital Production System - Customer Expectations Document- 35 -performance with each technology. Xerox papers and specialty media are digitally optimized (paper specs -smoothness, formation, electrical properties, etc., for optimal image quality, toner adhesion andperformance, and also precision sheeted - less contamination, better registration for use in Xerox digitalequipment.• Two feed modules in tandem may be installed on the input side of the printer.SPECIAL STOCKSCarbonlessXerox Carbonless Papers as listed in this document are the onlyrecommended carbonless media. Only simplex printing is supported onthis stock type. Running carbonless paper may require additionalcleaning time by the CSE during service of the machine. This time willvary based on the percentage of carbonless stock run. In the 100%carbonless usage case, service time could be up to 60 additional minutesper service call at 150,000 printsDocuCards®DocuCards® can only be loaded 100 at a time in a tray. Nuvera® feedertrays feed until almost empty but not until empty, leaving 20~40 sheetsremaining. When running DocuCards®, frequent reloading of the feedertrays will be required.DocuCards® can only be run to the Top Tray of the finisher. Some mis-stacking may occur as the DocuCards® catch on the edges of the stacked sheets®.When using DocuCards, it is recommended that you use a Tiltatron (available from CAS).Reinforced stocksReinforced stocks such as Mylar tabs should be limited to 90 loaded in a trayat one time.TransparenciesThe tray capacity for removable stripe transparencies is 90 sheets. There isno constraint for feeding painted striped transparencies or stripelesstransparencies.Tab JobsRunning tabs requires proper use of the supplied Tab Guides.For configurations with the BFM or FTM, jobs should be run with straightcollated tabs. For configurations with the MFF, jobs must be run withreverse collated tabs (the number of segments should be 10 or less). Forthe MFF configurations, please also refer to the Crucial PerformanceExpectations section for comments on ‘Drilled Paper and Tab jobs’.Tab stock sizes supported are: Letter, 9” x 11,” 9.5” x 11”, A4EnvelopesEnvelopes should be limited to 60 loaded in a tray at one time. Nuvera® feedertrays feed until almost empty but not until empty, leaving 20~40 sheetsremaining. When running envelopes frequent reloading of the feeder trays willbe required.Very slight wrinkles (1/2 inch long) may occur on the trail edge of envelopes at the corners.Due to the nature of feeding envelopes with flap open, some mis-stacking may occur in the top tray as theenvelopes catch on the open flapsEnvelopes should be sent to the Top Tray only. For the MFF configurations, the maximum limit is 15.2-Tray LFSFM4-Tray SFM