5-1 0 DocuTech 128/155/180 HighLight Color Operator GuideTechnical informationDo not use the following stocks:• Multipart forms• Stocks outside of the recommended size and weight rangesUsing non-standard stockUsing stock of non-standard width or length in the printer mayhave a negative impact on system performance. Refer to thefollowing table for a listing of sizes and possible resulting impacts.Table 5-6. Stock width impact on system performanceTextured paper Heavily textured paper may produce printswith a ragged character appearance ordeletions. To test, run a proof print.Window stock Run if the window is 2.2 to 4 inches (57 to102 mm) from the top edge of the paper andat least 1 inch (25.4 mm) from each side ofthe paper.Run only as the first page or a front cover toavoid finisher bin jams.Load the window stock face-up into a tray(tray 1 or 2 is recommended) with the topedge toward the front of the tray.If running plastic-covered window stock,there may be some distortion. To test, run aproof copy.Xerox Carbonless Xerox Carbonless Paper is recommended.Stock Type Instructions for useStock width Impact on performance8.67 to 9 inches (221to 229 mm) in trays 1,2, 3, 4, and 5Extended runs may increase the risk oftemporary background.Increased risk of lead-edge image deletions oneach successive sheet.Stock programming errors may go undetectedbecause stock width checking is not performed.9 inches (229 mm) toless than 14.2 inches(361 mm) in trays 3,4, and 5.Image offset may occur following a printermalfunction; for example, fuser jams.Running stock wider than 9 inches (229 mm)(other than 17 x 11 inches or A3) may increasethe risk of misregistration, skew, and tray 3elevator problems.
