Xerox DocuColor 2006 1-1Setting up the DocuColor 2006This chapter contains the hardware installation instructions only. To install the printerdriver software, go to the Installing your user software chapter. To install to thenetwork, go to the appropriate chapter for your operating system.Preparing for the installationBefore you begin the installation of your Xerox DocuColor 2006, read thisentire section. You must locate an appropriate site for the installation of theDocuColor 2006. Reading this section assists you with the decision makingprocess.Selecting a locationWARNINGThe wall outlet must be rated for 115 or 240 volts. It must also be protectedfor at least 15 amps for 115 volts, or 8 amps for 240 volts. If you are indoubt about a power source, ensure that a qualified electrician checks theoutlet.Do not connect any other devices to the wall outlet designated for the XeroxDocuColor 2006.Install the Xerox DocuColor 2006 in a location that meets the followingconditions:• The DocuColor 2006 has a designated wall outlet.• The power cord cannot be stepped on, or be a tripping hazard.• The location has a level, stable surface.DO NOT install the DocuColor 2006 in a location that has any of the followingconditions:• In direct sun light • Near an air conditioner or heater• In a dusty place • Near an open flame• In a windy place • Near water• Where it might be subject tovibration• Near a magnetic field• Where abrupt changes in temperature or humidity occur1
