20. Using ColorWise Pro ToolsXerox DocuColor 200620–4Checking Calibration StatusYou can check whether the Fiery is calibrated, which calibration set andoutput profile were used, and when the copier was last calibrated:• Print a Configuration page or Test Page from the Control Panel.• When you select a calibration set in Calibrator, the last calibration andthe user who performed it are displayed.Using a DensitometerColorWise Pro Tools are designed to work with the X-Rite DTP32 reflectiondensitometer where color measurements are entered automatically.Setting up the DensitometerBefore you calibrate the Fiery, you need to connect, configure, and calibratethe densitometer to prepare for measuring the printed patches. For additionalinformation about setting up and using the densitometer see thedocumentation included with it.To Connect the X-Rite DTP32 to the Computer1. Turn off the computer.2. Plug the square end of the interface cable (looks like a modular phoneplug) into the I/O port on the side of the X-Rite DTP32.3. Attach the connector to the computer.For a Windows computer, insert the 8-pin mini-DIN end of the interfacecable into the 9-pin DB9 Connector cable adapter. Insert the 9-pin endinto the COM1 or COM2 port on the computer and tighten the screws. Ifthe available port on your computer is 25-pin, you must use the 8-pin to25-pin adapter.For a Mac OS computer, connect the 8-pin mini-DIN plug directly intothe serial port of the computer.For Macintosh computers with a USB port, you need an adapter to connect theDTP32 to your computer. See the X-Rite, Inc. web site at www.x-rite.com forinformation on supported adapters.4. Use the AC adapter to provide power.Plug the small connector on the adapter cable into the side of the X-RiteDTP32 and plug the adapter into a wall outlet.5. Turn on the computer6. Calibrate the densitometer.7. Use ColorWise Pro Tools to calibrate the Fiery.
