OSS (OPERATING SYSTEM SOFTWARE) MESSAGESOS3705 Suspected set delivery error.There is an apparent set delivery problem.Action Visually inspect the sets.OS3710 Set integrity problem. Partial set ejected.The integrity of the current set in the stitcher/stacker‘s collectionarea is questionable; i.e., a page has been skipped.Action 1. Check the output.2. Press the key to resume printing.The message may also appear when a printer fault occurs or ifthe printer is powered off.OS Level 4: System or tape problemStates a problem and explains what action(s) to take.OS4010 Cannot find end of tape reflector strip. ‘CONTINUE I’The system did not encounter the End of Tape (EOT) label.Action 1. Enter the ABORT I command to cancel the job.2. Clean the magnetic tape drive to ensure read was accurate.(Refer to the maintenance chapter in your 4635 LPS OperatorGuide.)3. Restart the job. If the message reappears, do one of thefollowing:a. Enter the CONTINUE I command to resume processing.If any “Label Error” messages appear, continue pressingthe key until the job prints.Note: Check output for pages formatted incorrectly. You maywish to recreate the job.orEnter the ABORT I command to cancel the job.b. Check JSL and make any changes necessary. (Refer toyour 4635 LPS Operations Reference chapter on jobcontrol.c. If there are no JSL errors, enter the START n, DUMPcommand to obtain a tape dump for analysis.d. Recreate the job, ensuring tape labels are correct. (Referto your 4635 LPS Tape Formats Manual.)XEROX 4635 LASER PRINTING SYSTEM MESSAGE GUIDE 6-71
