8. Type the name of your primary file servers for the printer in the File Server field.NoteSet this item only when the operation mode is in Bindery Service.9. Type a number from 1 through 100 in the Number of Searches field.Type 0 for no limit.10. Select Enabled to enable the TBCP Filter.NoteThe TBCP Filter checkbox will have a checkmark in it indicating that the TBCP Filteris enabled.11. Type a name for the NDS tree in the NDS Tree field.The default entry for this field is Xerox_DS_Tree. If you are using Bindery mode, leavethis field blank.12. Type a context in the NDS Context field.The default entry for this field is Xerox_DS_Context. If you are using Bindery mode,leave this field blank.NoteSet this item only when the operation mode is in Directory Service.13. For Service Location Protocol, select Enabled to enable SLP - Active Discovery.14. Next to Use SLP for Name Resolution, select Enabled.15. Type the scope name in the Scope field.16. Type the SLP server address in the SLP Server field.17. Select Apply.TCP/IPTransmission Control Protocol (TCP) and Internet Protocol (IP) are two protocols withinthe Internet Protocol Suite. IP manages the transmission of messages from computerto computer while TCP manages the actual end-to-end connections. This section describesthe how to configure settings for TCP/IP.You can configure IPv4 settings at the printer control panel or through CentreWare IS.You can only configure IPv6 through CentreWare IS. By default, TCP/IP is enabled. Itmust be enabled at the printer control before you can access CentreWare.IPv6 is optional and may be used in addition to or in place of IPv4. IPv6 hosts canautomatically configure themselves when connected to a routed IPv6 network usingInternet Control Message Protocol Version 6 (ICMPv6). ICMPv6 performs error reportingfor IP along with other diagnostic functions. When first connected to a network, a hostsends a link-local multicast router solicitation request for its configuration parameters.Routers respond to this request with a router advertisement packet containingnetwork-layer configuration parameters.1. Perform the following to access the network protocol settings.a. Connect to CentreWare Internet Services.Xerox® D95/D110/D125/D136 Copier/Printer3-6System Administration GuideUsing CentreWare Internet Services
