80 4 Settings on the Control PanelPJL *2 (refer to P. 94)This printer supports PJL commands that are independent from any printer languages. ThePJL commands are used to control print jobs and are required for printing using a printerdriver. In this menu, specify whether to enable or disable the PJL commands sent from acomputer. PJL commands allow you to specify the printer language to be used for the nextdata even while the printer is using a different printer language at the time. Normally, itshould be set to [Enable]. The default is [Enable].USBSelect this to use USB ports.Port StatusSpecifies whether to enable or disable the USB port when the printer turns on. The defaultis [Enable], which means the USB port is available.Important• If the memory is running out, you need to disable the port(s) you are not using or change the memoryallocation from [Allocate Memory].Print Mode*1 (refer to P. 94)Sets the print data process method (printer language to be used).[Auto] (default)Select this to make the printer automatically detect the printer language being used in thedata received from a computer and perform printing based on the detected data.[PCL] [PS] [HP-GL/2] [TIFF]Select this to process the data received from a computer as the specified data type.Note• [PS] is displayed only when the PostScript software kit (optional) is installed.PJL *2 (refer to P. 94)This printer supports PJL commands that are independent from any printer languages. ThePJL commands are used to control print jobs and are required for printing using a printerdriver. In this menu, specify whether to enable or disable the PJL commands sent from acomputer. PJL commands allow you to specify the printer language to be used for the nextdata even while the printer is using a different printer language at the time. Normally, itshould be set to [Enable]. The default is [Enable].Auto Eject Time*3 (refer to P. 94)Sets the time interval for the printer to automatically print the remaining data when no furtherdata is received for a continuous period.The time can be set between 5 to 1275 seconds in increments of 5 seconds. The default is[30 Secs]. When no data is received for the period specified here after the last data wasreceived, the printer determines it as job end.
