Xerox PHASER 5400 Quick Install Manual

Also see for 5400DX - Phaser B/W Laser Printer: User guide Technical instructions Manual Installation instructions Paper guide

Xerox PHASER 5400 Quick Install Manual Manual pdf 13 page image

Quick Network Install Guide 7Windows NT 4.x NetworkIntroductionYour printer can be installed on a Windows NT network using one ofthree methods: Microsoft TCP/IP protocol Xerox TCP/IP Port Monitor AppleTalk protocolThe Preliminary Steps given below must be accomplished for allprinters regardless of the method that is being used. Then, the QuickInstall Steps detail the installation process corresponding to themethod selected.The CentreWare DP program on your Printer Management SoftwareCD-ROM can also be used to monitor and configure the printer.Preliminary steps1. Print the Configuration Sheet. Details are in this document inAppendix A: Print the Configuration Sheet. Retain this page forreference.2. Check the Configuration Sheet and verify that both the desiredprotocol and connector are enabled.3. Proceed to the Quick Install Steps for the installation methodselected.Quick install steps (Microsoft TCP/IP protocol)1. At the Desktop, right-mouse-click the Network Neighborhoodicon and select Properties.2. Click on the Protocols tab and verify that the TCP/IP protocol hasbeen loaded.3. Select the Services tab and verify that Microsoft TCP/IP Printingis loaded.4. If this software is not present, install it using the documentationprovided by Microsoft, and then return to this document.