Xerox PHASER Phaser 4400 Paper Manual
Also see for 4400N - Phaser B/W Laser Printer: Specification sheetSetup guideTroubleshooting guide
                                          | |
Contents
|
Output TraysPhaser™ 4400 Laser Printer 34Offsetting outputWhen you send output to the 500-sheet stacker, you can also select offsetting. Offsetting separates printjobs or collated sets of a single job by approximately 25 mm (1 in.) in the output tray.NoteIf you send output to the Standard Output Tray, the printer does not offset the output.The 500-sheet Stacker offsets output, but you must have a hard drive to have the printeroffset collated sets.You can switch job offsetting on or off on the front panel:1. With Menus highlighted, press the OK key.2. Scroll to Printer Setup Menu using the Up Arrow or Down Arrow key and press OK.3. Scroll to Job Defaults Menu and press the OK key.4. Scroll to Job Offset.5. Select either On or Off by pressing the OK key.NoteIf you change job offsetting in your printer driver, this overrides the front panel setting foryour print jobs. |
Related manuals for Xerox 4400N - Phaser B/W Laser Printer
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine