Xerox Phaser 3320DN System Administrator Manual

Also see for Phaser 3320DN: User guide

Contents

Machine Parts and Connection PortsXerox Phaser 3320DN/3320DNISystem Administrator Guide162. Press the arrow buttons to highlight Network Setup and press OK.3. Enter the Administrator Password using the arrow buttons. The default is 1111. Refer to Entering apassword: on page 14.4. Use the arrow buttons to scroll to Ethernet Speed and press OK.5. Use the arrow buttons to select one of the following speeds:• Automatic• 10 Mbps Half• 10 Mbps Full• 100 Mbps Half• 100 Mbps Full• 1 Gbps Full6. Press OK. The Please Reboot message displays.To reboot the machine, press the power switch off, wait two seconds and press the power switchback on.To set the Ethernet Speed using Internet Services, refer to Setting the Ethernet Speed Using InternetServices on page 20.Print a Configuration ReportThe Configuration Report details the machine software versions and network settings configured forthe machine.Print a Configuration Report at the Machine1. Press the Menu button.2. Press the arrow buttons to scroll to Information and press OK.3. Press the arrow buttons to select Configuration and press OK.Use the arrow buttons to select Yes and press OK. The configuration report will print.You can also print the Configuration Report using Internet Services. Refer to Status on page 81.Install the Additional Memory Card (Optional)The machine supports memory expansion through the installation of an additional memory card.Memory expansion is an option for the machine.The machine has a dual in-line memory module (DIMM). Use this memory module slot to installadditional memory.1. Turn the machine off and unplug all cables from the machine.2. Grasp the control board cover and remove it.3. Remove the new memory module from its bag.