TCP/IPXerox Phaser 3320DN/3320DNISystem Administrator Guide25DNS Configuration:12. From the TCP/IP (IPv4) menu, press the arrow buttons to select Static; press OK.13. Press the arrow buttons to highlight Primary DNS; press OK.14. Enter details for Primary DNS using the arrow buttons and press OK. The Saved screen willdisplay and return to the Static menu.15. Press the arrow buttons to highlight Secondary DNS; press OK.16. Enter details for Secondary DNS using the arrow buttons and press OK. The Saved screen willdisplay and return to the Static menu.Configure Dynamic IPv4 Addressing at the MachineInformation ChecklistBefore starting please ensure that the following items are available and/or the tasks have beenperformed:• Existing operational network utilizing the TCP/IP protocol.• DHCP or BOOTP Server should be available on the network.• Ensure that the machine is connected to the network.ProcedureInstallation via DHCP (Dynamic Host Configuration Protocol)DHCP is enabled on the machine by default. If the machine is connected to the network, the TCP/IPinformation will be configured when the machine is powered on and no further configuration isrequired.1. Print a Configuration Report to verify that the information was assigned correctly. Refer to Printa Configuration Report on page 16.Installation via BOOTP or DHCPEnsure your machine is connected to the network with Ethernet cabling.1. Press the Menu button on the control panel.2. Use the arrow buttons to scroll to Network Setup; press OK.3. Enter the Administrator Password using the arrow buttons. The default is 1111. Refer to Entering apassword: on page 14.4. Press the OK button.5. Press the arrow buttons to scroll to TCP/IP (IPv4); press OK.6. Press the arrow buttons to select DHCP; press OK.7. The Saved screen will display and return to the Network Setup menu.