Service Parts DisassemblyXerox Internal Use Only Phaser 3330 and WorkCentre 3335/3345Service Manual4-13Covers and DoorsFront DoorWARNING: Do not perform repair activities with the power on or electrical power supplied to themachine. The machine could activate and cause serious personal injury when the power is on orelectrical power is supplied.Parts List 1.0 Phaser 3330 Main1. Do the preparations (page 4-3).2. If this printer is on the Optional Tray 2 Base, remove it from the base and disconnect theConnector CN35 (page 4-8).3. Remove Tray 1 (page 4-6).4. Remove the Toner Cartridge and Photoreceptor Drum Cartridge (page 4-5).CAUTION: If the Front Door is removed, do not attempt to remove the Drum Cartridge withoutpulling the black coupling bar (that holds the left side of the Front Door) forward so that it retractsthe pin that holds the Drum Cartridge in place. Attempting to remove the Drum Cartridge withoutreleasing this pin could result in toner spillage and possible damage to the machine.5. Disconnect the arm on the left hand side of the printer, release left hook and then the right hookto remove the Front Door (Parts List 1.0 Phaser 3330 Main, PL 1.3.1).CAUTION: Do not damage the wires when removing the cover.6. Loosen or remove the Right Cover (page 4-17)as necessary, to gain access to and then disconnectthe Connector located behind the Right Cover.Note: Press inward on one side of the cover to release it, then repeat that action to release theother sideNote: If the Front Door is replaced, the Tag Matrix Label must be peeled off and placed on thenew Front Door.Rear DoorParts List 1.0 Phaser 3330 MainWARNING: Do not perform repair activities with the power on or electrical power supplied to themachine. The machine could activate and cause serious personal injury when the power is on orelectrical power is supplied.1. Do steps 1-4 in Preparations (page 4-3)2. Remove the Duplex Assembly (page 4-7).3. Open the Rear Door (Parts List 1.0 Phaser 3330 Main, PL 1.0.11).
