Xerox Phaser 3428 User Manual

Contents

Xerox Phaser 3428 User Manual Manual pdf 19 page image

2.6 <System setup>Network menu (Phaser 3428/DN only)This menu lets you configure the network interface installed in yourprinter. You can reset the network interface and print a configurationpage.CharacterTab.This item selects the character set.PitchYou can determine the font size by setting the numberof characters that will print in one horizontal inch oftype.LPIYou can set the number of lines printed in one verticalinch.AutoWrapThis item determines whether or not the printerautomatically performs line feed when the dataoverflows the printable area of the print material.Item ExplanationTCP/IPThis item allows you to manually set the TCP/IPaddresses or receive the addresses from thenetwork.• DHCP: The DHCP server allots the IP address toyou automatically.• BOOTP: The BOOTP server allots the IP addressto you automatically.• Static: You can enter IP address, subnet mask,and gateway manually.EtherTalkThis item lets you select whether or not you use theEtherTalk protocol.Item ExplanationValues: ITALIC, PC437US, PC850Values: 10, 12, 17.14, 20Values: 6, 8Values: Off, OnValues: DHCP, BOOTP, StaticValues: Off, OnPrinting a demo pagePrint a demo page to make sure that the printer is operating correctly.1 Press Menu and then OK when Information appears.2 Press the Scroll buttons until Demo Page appears and press OK.A demo page prints out.Changing the display languageTo change the language that is displayed on the control panel, followthese steps:1 Press Menu until System Setup appears on the bottom line of thedisplay and press OK.2 Press OK when Language appears.3 Press the Scroll buttons to select the language you want and pressOK.4 Press Stop to return to Standby mode.NetWareThis item lets you select the IPX frame type.• Auto: You can set the frame type automatically.• 802.2: Select this value to use the IEEE 802.2frame type.• 802.3: Select this value to use the IEEE 802.3frame type.• Ethernet II: Select this value to use the Ethernet 2frame type.• SNAP: Select this value to use the SNAP frametype.• Off: You can disable the NetWare protocol.EthernetSpeedThis item allows you to select the ethernet speed.ClearSettingThis item performs a simple reset and restores thefactory default settings for the networkconfiguration. This setting will only take effect afteryou have reset the printer.NetworkInfo.This item print a page showing the networkparameters you set.Item ExplanationValues: Auto, 802.2, 802.3, Ethernet II, SNAP, OffValues: Auto, 10M Half, 10M Full,100M Half, 100M Full