Xerox Phaser 3600 User Manual

Also see for Phaser 3600: Features Options guide Installation guide Letter of volatility Quick use guide

Contents

2.8 <System setup>PostScriptThis menu provides you with the Print PS Error menu item.EPSONThis menu sets the EPSON emulation configuration.LinesThis item allows you to set vertical spacing from 5 to128 lines for the default paper size. The lines maydiffer according to the paper size and printingorientation.Item ExplanationPrint PSErrorYou can select whether or not your printer prints anerror list when a PS error occurs.• Select On to print PS 3 emulation errors. If an erroroccurs, the job stops processing, the error messageprints, and the printer flushes the job.• If this menu is set to Off, the job is flushed without anindication of the error.Item ExplanationFontYou can select the standard font that will be used inEPSON emulation.CharacterSetThis item allows you to select a character set of thedesired language.CharacterTab.This item selects the character set.PitchYou can determine the font size by setting the numberof characters that will print in one horizontal inch oftype.Item ExplanationValues: 5 ~ 128 (1 unit)Values: On, OffValues: SANSERIF, ROMANValues: USA, FRANCE, GERMANY, UK,DENMARK1, SWEDEN, ITALY, SPAIN1, JAPAN,NORWAY, DENMARK2, SPAIN2, LATINValues: ITALIC, PC437US, PC850Values: 10, 12, 17.14, 20Network menu(Phaser 3600/N, Phaser 3600/DN only)This menu lets you configure the network interface installed in yourprinter. You can reset the network interface and print a configurationpage.LPIYou can set the number of lines printed in one verticalinch.AutoWrapThis item determines whether or not the printerautomatically performs line feed when the dataoverflows the printable area of the print material.Item ExplanationTCP/IPThis item allows you to manually set the TCP/IPaddresses or receive the addresses from thenetwork.• DHCP: The DHCP server assigns the IP addressto you automatically.• BOOTP: The BOOTP server assigns the IPaddress to you automatically.• Static: You can enter IP address, subnet mask,and gateway manually.EtherTalkThis item lets you select whether or not you use theEtherTalk protocol.• Off: You can disable the EtherTalk protocol.• On: You can enable the EtherTalk protocol.NetWareThis item lets you select the IPX frame type.• Auto: You can set the frame type automatically.• 802.2: Select this value to use the IEEE 802.2frame type.• 802.3: Select this value to use the IEEE 802.3frame type.• Ethernet II: Select this value to use the Ethernet 2frame type.• SNAP: Select this value to use the SNAP frametype.• Off: You can disable the NetWare protocol.Item ExplanationValues: 6, 8Values: Off, OnValues: DHCP, BOOTP, StaticValues: Off, OnValues: Auto, 802.2, 802.3, Ethernet II, SNAP, Off