Installation and Setup50 Xerox ® Phaser® 6022 PrinterUser GuideConfiguring General Setup Using the ControlPanelThis section includes:• Getting Information About the Printer ...................................................................................................................... 50• Configuring System Settings........................................................................................................................................... 50Getting Information About the Printer1. At the printer control panel, press the Menu button.Note: To navigate through the menu, use the up or down arrow buttons.2. Navigate to Information Pages.3. To scroll through the information pages, use the Up or Down arrows.4. To print a specific information page, press OK.Configuring System SettingsYou can use this menu to configure general settings of the printer, such as Power Saver timers, clocksettings, and alert settings.Accessing the System Setup Menu1. At the printer control panel, press the Menu button.Note: To navigate through the menu, use the up or down arrow buttons.2. Use the Up and Down arrows to navigate to Admin Menu, then press OK.3. Navigate to System Setup, then press OK.Configuring Power Saver ModeYou can set the time the printer spends idle in ready mode before the printer transitions to a lowerpower level.There are two levels of Power Saver mode.• Mode 1 (Low Power): The printer shifts from Ready mode to Low Power mode to reduce standbypower consumption.• Mode 2 (Sleep): The printer shifts from Low Power mode to Sleep mode for a greater reduction inpower consumption.
