User SafetyPhaser® 6280 Printer9Note: Leave the printer on for optimum performance; it does not pose a safety hazard. Ifhowever the printer will not be used over an extended period of time, it should be turnedoff and unplugged.The following are hazards to your safety:• The power cord is damaged or frayed.• Liquid is spilled into the printer.• The printer is exposed to water.If any of these conditions occur, do the following:1. Turn off the printer immediately.2. Disconnect the power cord from the electrical outlet.3. Call an authorized service representative.Laser SafetyWith specific regard to lasers, this printer complies with laser product performancestandards set by governmental, national, and international agencies and is certified as aClass 1 Laser Product. The printer does not emit hazardous light because the beam istotally enclosed during all modes of customer operation and maintenance.Maintenance Safety• Do not attempt any maintenance procedure that is not specifically described in thedocumentation supplied with your printer.• Do not use aerosol cleaners. The use of supplies that are not approved may cause poorperformance and could create a hazardous condition.• Do not attempt to open, reuse, or burn any consumables or routine maintenanceitems. For information on Xerox supplies recycling programs, go towww.xerox.com/gwa.Operational SafetyYour printer and supplies were designed and tested to meet strict safety requirements.These include safety agency examination, approval, and compliance with establishedenvironmental standards.Your attention to the following safety guidelines helps to ensurethe continued, safe operation of your printer.Printer LocationPlace the printer in a dust-free area within a temperature range of 41° F to 90° F (5° C to32° C) and a relative humidity range of 15 percent to 85 percent.
