Configuring the Network AddressPhaser® 7400 Color Printer2-6Dynamic Methods of Setting the Printer’s IP AddressSet the printer’s IP address using any of the following methods. DHCP is enabled by default onall Phaser printers.■ DHCP■ CentreWare IS■ AutoIPEnabling DHCP on the PrinterVerify that the printer DHCP protocol is enabled by setting the control panel or by usingCentreWare IS. DHCP is enabled by default on all Phaser printers.Note: To determine the printer’s IP address, select Printer Identification on the controlpanel.See also:Control Panel Features on page 1-8Changing or Modifying the IP Address Using CentreWare ISCentreWare IS provides a simple interface that enables you to manage, configure, and monitornetworked printers from your desktop using an embedded web server. For completeinformation about CentreWare IS, click the Help button in CentreWare IS to go to theCentreWare IS Online Help.After setting the printer’s IP address, you can modify TCP/IP settings using CentreWare IS.1. Launch your web browser.2. Enter the printer’s IP address in the browser’s Address field (http://xxx.xxx.xxx.xxx).3. Click Properties.4. Select the Protocols folder on the left sidebar.5. Select TCP/IP.6. Enter or modify the settings, and then click Save Changes at the bottom of the page.Information Required for Manual IP AddressingInformation CommentsInternet Protocol (IP) address of the printer Format is xxx.xxx.xxx.xxx, where xxx representsa decimal number from 0–255.Network Mask If you are unsure, leave this blank; the printerchooses an appropriate mask.Default Router/Gateway address Router address is required to communicate withthe host device from anywhere other than thelocal network segment.
