User safety summaryTerms in manualCAUTION Conditions that can result in damage to the product.WARNING Conditions that can result in personal injury or loss of life.Power source: For 110 VAC printers, do not apply more than 130 volts RMS betweenthe supply conductors or between either supply conductor and ground. Use only thespecified power cord and connector. For 220 VAC printers, do not apply more than 250volts RMS between the supply conductors or between either supply conductor and ground.Use only the specified power cord and connector. Refer to a qualified service technicianfor changes to the cord or connector.Operation of product: Avoid electric shock by contacting a qualified servicetechnician to replace fuses inside the product. Do not operate without the covers andpanels properly installed. Do not operate in an atmosphere of explosive gases.WARNING Turning the power off using the On/Off switch does not de-energizethe printer. You must remove the power cord to disconnect theprinter from the mains. Keep the power cord accessible for removalin case of an emergency.Safety instructions: Read all installation instructions carefully before you plug theproduct into a power source.Terms on productCAUTION A personal injury hazard exists that may not be apparent. Forexample, a panel may cover the hazardous area. Also applies to ahazard to property including the product itself.DANGER A personal injury hazard exists in the area where you see the sign.Care of product: Disconnect the power plug by pulling the plug, not the cord.Disconnect the power plug if the power cord or plug is frayed or otherwise damaged, ifyou spill anything into the case, if product is exposed to any excess moisture, if product isdropped or damaged, if you suspect that the product needs servicing or repair, andwhenever you clean the product.Ground the product: Plug the three-wire power cord (with grounding prong) intogrounded AC outlets only. If necessary, contact a licensed electrician to install a properlygrounded outlet.Symbols as marked on product:
