Printing on Specialty MediaPhaser® 8510/8560MFP Multifunction Product3-29Printing on Specialty MediaThis section includes:■ Printing Transparencies on page 3-29■ Printing Envelopes on page 3-35■ Printing Labels on page 3-41■ Printing Glossy Paper on page 3-47■ Printing Custom Size Paper on page 3-52Printing TransparenciesTransparencies can be printed from any tray. They should be printed on one side only. For bestresults, use only recommended Xerox transparencies.See also:Recommended Media List (United States)Recommended Media List (Europe)To order paper, transparencies, or other specialty media, contact your local reseller or go towww.xerox.com/office/supplies.Caution: Damage caused by using unsupported paper, transparencies, and other specialtymedia is not covered by the Xerox warranty, service agreement, or Total SatisfactionGuarantee. The Total Satisfaction Guarantee is available in the United States and Canada.Coverage may vary outside these areas; please contact your local representative for details.Guidelines■ Remove all paper before loading transparencies in the tray.■ Handle transparencies by the edges using both hands. Fingerprints or creases can causepoor print quality.■ Do not load more than 50 transparencies in Tray 1. Do not load more than400 transparencies in Tray 2, 3, or 4. Overloading the tray can cause the system to jam.■ Do not use transparencies with stripes on the side.■ After loading transparencies, change the paper type at the control panel:a. Press the System button.b. Select Paper Tray Setup, and then press the OK button.c. Select the appropriate tray, and then press the OK button.d. Select Change setup, and then press the OK button.e. Select paper size and type for Tray 1; select paper type for Tray 2, 3, or 4.f. Press the OK button.
