Xerox SquareFold Trimmer Module User Manual

Also see for SquareFold Trimmer Module: User guide

Contents

Xerox SquareFold Trimmer Module User Manual Manual pdf 11 page image

User Guide 7OverviewSquareFold Trimmer Module1.2.3.4.5.SaveOffBooklet Trimming / PressingOnCancelTrimmingPaper Supply...Tray 18.5 x 11"PlainCut to SizeSelect a landscape paperand then adjust to the sizeyou want to cutBook PressingOffOnPressure AppliedHigherNormalHighLowLowerThe Square Fold (Book Pressing) options are found in the following areas:On the SquareFold Trimmer Module control panel•On the machine's UI•From the print server on the• Properties window for a selected network print job, andFrom the• Properties window of a selected print job on your workstationSquare Fold optionsThe Square Fold (Book Pressing) feature can be switched on or off based on user preference. When the feature isswitched on, you can select one of five options depending on your requirements for the finished booklet job.For the remainder of this section, only the SquareFold Trimmer Module Control Panel and the machine's UI are shown.The descriptions given for each of the Square Fold options are applicable for both copy and network print jobs, andapplies to any print server connected to the machine. To see the actual screens for each print server, go to the desiredprint server and follow the instructions given in the previous section entitled "Network print jobs."Note+2/Higher: Use this setting when you want the most amount ofpressure applied to the spine of the booklet. The more pressureapplied to the booklet, the more square the booklet spine will be. +2is the greatest amount of pressure that can be applied to thebooklet.Additionally, you may want to select this setting when your finishedbooklet is five pages or less and on heavier weight paper (200 gsm orgreater).+1/High: Use this setting when you want a greater amountof pressure applied to the spine of the booklet, but not asmuch pressure as the +2 setting uses.5.4.3.2.1.Auto/Normal: This is the machine default setting and isused for most jobs.-1/Low: Use this setting when you want less pressureapplied to the spine of the booklet. The less pressureapplied to the booklet, the more rounded the booklet spinewill be.-2/Lower: Select this setting when your finished booklet is five pages or less and on lighter weight paper (100gsm or lower). -2 is the least amount of pressure that can be applied to the booklet.Choose the setting that best fits your needs for the booklet output.