Xerox SquareFold Trimmer Module User Manual

Also see for SquareFold Trimmer Module: User guide

Contents

Xerox SquareFold Trimmer Module User Manual Manual pdf 15 page image

User Guide 11OverviewSquareFold Trimmer ModuleSaveOffBooklet Trimming / PressingOnCancelTrimmingPaper Supply...Tray 311 x 17"PlainCut to SizeBook PressingOffOn0 mm195.8 213.81.2.Booklets exiting/leaving the SquareFold Trimmer Module may contain trim remnants/scraps from the previouslytrimmed booklet. This is due to static electricity build-up and is normal. If booklets contain trim remnants/scraps, simplyremove and discard them.Trim settings cannot be adjusted to remove less than 2 mm (0.078 in.) or more than 20 mm (0.787 in.) of edgematerial from the booklet. Adjustments less than 2 mm (0.078 in.) may produce poor trim quality, and adjustmentsgreater 20 mm (0.078 in.) will result in no trimming to the booklet edge.Touch the left/right arrow buttons to decrease or increasethe trimmer setting. Adjustments are made in 0.1mm/0.003 9 in. increments.Important!: You may have to experiment with various settings in order to determine the best settings for yourparticular job. Also, you may want to run one or more test prints/copies before running larger jobs in order to ensurethe best possible booklet output.The trimmer setting is based on:The number of sheets in the finished booklet,•The finished booklet• width size (such as 8.5 in./210mm or 5.5 in/149 mm),The media type (coated/uncoated, glossy, etc.),•andThe media weight•TipThe Trimmer options are found in the following areas:On the machine's UI•From the print server on the• Properties window for a selected network print job, andFrom the• Properties window of a selected print job on your workstationTrimmer optionsThe Trimmer feature can be switched on or off based on user preference. When the feature is switched on, you canadjust the trim setting in 0.1 mm/0.003 9 in. increments depending on your requirements for the finished booklet job.For the remainder of this section, only the machine's UI is shown. The descriptions given for the Trimmer options areapplicable for both copy and network print jobs, and applies to any print server connected to the machine. To see theactual screens for each print server, go to the desired print server and follow the instructions given in the previoussection entitled "Network print jobs."NoteChoose the setting that best fits your needs for the booklet output.1.2.TipNote