Xerox Synergix 8825 Supplementary Manual

Also see for Synergix 8825: User guide Setup guide User guide Release note System introduction

Contents

Xerox Synergix 8825 Supplementary Manual Manual pdf 14 page image

XES Synergix 8825/8830/8855 Digital Solution Folding Supplement 8Title Block Position Solutions ChartTypically, print jobs that consist of files that are standard drawing sizes, printed on standard media sizes available in the printer will be folded with the title blockvisible on the folded package. If there is a problem getting the title block positioned as desired, refer to the Chart and begin with Solution 1 to try and isolate theproblem.Solutions AccXES Client Tools Web PMTWindows OptimizedHP-GL/2 Driver(95/98/NT 4.0/2000) Postscript Driver1Verify Folder iscapable of makingthe desired fold .• Reference the User Documentation provided with the Folder and check that a Fold Style is available that will position the titleblock in the desired position.If the style is available, continue with Solution 2. If a style is not available, the desired fold is non-conforming and cannot befolded.2Verify that the FoldStyle program isenabled on theFolder.• At the Folder Operator Control Panel, check that the desired Fold Style program is enabled.If enabled, continue with Solution 3. If not enabled, load the Fold Style program and run the print job again. Loading the programmay require that the printer and controller be switched off then on (rebooted) or Service be called.3Verify that themedia loaded in thePrinter will allow thedesired Fold Styleto be folded.• Check that the media series (ARCH, ANSI, or ISO) in the printer match the available Fold Styles and or Folder Type.• Load the standard width media rolls in the printer for the media series being used.Run the print job again. If the job is incorrect, continue with Solution 4.