Xerox Trimmer Module SquareFold User Manual

Also see for SquareFold Trimmer Module: User guide

Contents

Xerox Trimmer Module SquareFold User Manual Manual pdf 12 page image

OverviewSquareFold Trimmer User Guide81.2.Trimmer settingTip: Booklets exiting/leaving the SquareFold TrimmerModule may contain trim remnants/scraps from thepreviously trimmed booklet. This is due to static electricitybuild-up and is normal. If booklets contain trimremnants/scraps, simply remove and discard them.Trimmer Mode Settings2.1. Trimmer setting up/down buttonsNote: Trim settings cannot be adjusted to remove less than2 mm (0.078 in.) or more than 20 mm (0.787 in.) of edgematerial from the booklet. Adjustments less than 2 mm(0.078 in.) may produce poor trim quality, and adjustmentsgreater 20 mm (0.078 in.) will result in no trimming to thebooklet edge.The trimmer setting is based on:Note: Trim settings are always entered using millimeters(mm).Important!:You may have to experiment with varioussettings in order to determine the best settings for yourparticular job. Also, you may want to run one or more testprints/copies before running larger jobs in order to ensure thebest possible booklet output.Adjustments can be made in 0.1 mm increments by pressingthe up/down buttons on the Control Panel.The Trimmer Mode Settings are found on the SquareFoldTrimmer Module control panel. The settings can be switchedon or off based on user preference. When the settings areswitched on, you can enter a desired setting by pressing theup/down buttons.The number of sheets in the finished booklet,•The finished booklet• width size (such as 8.5 in./210 mmor 5.5 in/149 mm),The media type (coated/uncoated, glossy, etc.), and•The media weight•