Xerox Trimmer Module SquareFold User Manual

Also see for SquareFold Trimmer Module: User guide

Contents

Xerox Trimmer Module SquareFold User Manual Manual pdf 7 page image

Overview3SquareFold Trimmer User Guide1. 2.3. 5. 6.4.1.2. 3. 5.4.6.The booklet leaves the booklet area of the finisher and entersSquareFold Trimmer Module.Once the booklet spine reaches the square fold area, thebooklet is clamped and the square-folding operation begins.The booklet is flattened and the spine squared according tothe square-fold setting indicated on the control panel.For detailed information on each of Square Fold settings,refer to page 6.After the booklet is flattened and the spine squared, it ismoved to the trimmer area.The booklet then moves to the exit area where it istransported to the Booklet Output Tray.Paper pathThe Booklet Exit sensor (in the SquareFold Trimmer Module)detects the lead edge (spine) of booklet and moves thebooklet to square fold area.Based on the finished booklet size, the booklet is moveduntil the trail edge reaches the trimmer cutter.The trail edge is trimmed/cut (based on the finishedbooklet size entered for the Trimmer Mode Setting).1.2.3.4.5.a.b.6.Tip: Booklets exiting/leaving the SquareFold TrimmerModule may contain trim remnants/scraps from thepreviously trimmed booklet. This is due to static electricitybuild-up and is normal. If booklets contain trimremnants/scraps, simply remove and discard them.