PROBLEM SOLVING44 XEROX WIDE FORMAT 721P PRINTER OPERATOR MANUAL8. Trim the lead edge of the roll square to remove any torn orwrinkled media by using the ìSlitî if necessary.9. Insert the lead edge of the media between the upper andlower feed rollers and feed an inch of media between the feedrollers.10. Roll 3 only: Rotate the lower feed roller by hand until the leadedge is visible in the center of the viewing hole.11. Press the [Online] Key to take the printer Offline (LED Off).12. Push in the drawer until it is closed and latched.13. If the leading edge is not sufficiently square, perform theautomatic Initial Cut by pressing the [Select] key to select theappropriate drawer, and then pressing [Cut] key.Approximately 9.5î (240mm) media will be cut and fed fromthe printer.14. Press the [Online] Key to return the printer Online (LED On).Clearing Media Jam (J-22)SlitCutterMFD1D2D3 D4PFExitCopy Density Menu Enter Online1. Remove the jammed media from the Stacker.
