14Note: In using SNMPv3, use the IPSec protocol simultaneously. Therefore the IPaddress of the client for SNMPv3 have to be set according to the procedures 2.16Set IPSec 12.Enter the IP Address in the [Specify Destination IPv4 Address:] box.2.18. Set S/MIMEOn the Properties screen,1. Enter the Machine’s E-mail Address, under the Description hot link.Also note that to use E-mail with this machine, E-Mail has to be enabled andconfigured as stated in the Scan to E-mail section of System AdministratorGuide.2. Before setting, you will have to Import a S/MIME certificate according to sameprocedure as configuring Machine certificates.3. Click on [Certificate Management].4. Select the [S/MIME] for Certificate Purpose.5. Click [Display the list], and check a desirable Certificate.6. Click [Certificate Details].7. Click [Use this certificate].8. Click [+] on the left of [Security] folder.9. Click on [SSL/TLS Settings].10. Check the [Enable] box for [S/MIME Communication]11. Click [Apply].12. Click [Reboot Machine].Refresh the browser and Click [Properties] tab.13. Click [+] on the left of the [Security] folder.14. Click [S/MIME Settings].15. Remove the [Enable] check box for [Receive Untrusted E-mail]16. Click [Apply].NOTE: This feature is also able to utilize from Control Panel.「Connectivity & Network Setup」>「Security Settings」>「S/MIME Settings」2.19. Set Audit LogOn the Properties screen,1. Click [+] on the left of the [Security] folder.2. Click on [Audit Log].3. Check the [Enabled] box for Audit Log.4. Click [Apply].