Xilinx KC705 User Manual
Also see for KC705: User guideUser guideGetting startedUser guide
                                                                                                                     | |
Contents
| 
KC705 Evaluation Board 84UG810 (v1.8) March 20, 2018 www.xilinx.comAppendix A: Default Switch and Jumper SettingsDIP Switch SW13 Mode and Flash Memory AddressSettingsSee Figure 1-2, page 10 Item 29 for location of SW13. Default settings are shown inFigure A-2 and details are listed in Table A-2.The default mode setting M[2:0] = 010 selects Master BPI configuration at board power-on.Default Jumper SettingsSee Figure A-3 for the locations of jumpers listed in Table A-3.X-Ref Target - Figure A-2Figure A-2: SW13 Default SettingsTable A-2: SW13 Default Switch SettingsPosition Function Default1 FLASH_A25 A25 Off2 FLASH_A24 A24 Off3 FPGA_M2 M2 Off4 FPGA_M1 M1 On5 FPGA_M0 M0 OffUG810_aA_02_0312141SW13OFF Position = 0ON Position = 12 3 4 5A25A24M2M1M0Table A-3: KC705 Default Jumper SettingsCallout HeaderReferenceDesignatorJumperPosition Description Schematic0381502 Page2-pin1 J3 1-2 SPI SELECT = Onboard SPI flash memory device 262 J42 None U35 REF3012 XADC_AGND L17 bypassed 313 J43 1-2 U35 REF3012 XADC_AGND = GND 314 J53 None U55 UCD9248 RESET_B = LOGIC 1 (NOT RESET) 36Send Feedback |
Related manuals for Xilinx KC705
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine