ML605 Hardware User Guide www.xilinx.com 79UG534 (v1.9) February 26, 2019Appendix ADefault Switch and Jumper SettingsTable A-34: Default Switch SettingsREFDES Function/Type DefaultSW2 Board power slide-switch offSW1User GPIO 8-pole DIP switch8 off7 off6 off5 off4 off3 off2 off1 offS1System ACE CF configuration and image select 4-pole DIP switch4 SysACE Mode = 1 (1) off3 SysAce CFGAddr 2 = 0 off2 SysAce CFGAddr 1 = 0 off1 SysAce CFGAddr 0 = 0 offS2FPGA mode, boot PROM select and FPGA CCLK select 6-pole DIPswitch6 FLASH_A23 = 0 off5 M2 = 0 off4 M1 = 1M[2:0] = 010 = Master BPI-Up on3 M0 = 0 off2 CS_SEL = 1 = boot from BPI Flash on1 EXT_CCLK = 0 offNotes:1. S1 position 4 is the System ACE controller enable switch. When ON, this switch allows the SystemACE to boot at power on if it finds a CF card present. In order to boot from BPI Flash or Xilinx PlatformFlash without System ACE contention, S1 switch 4 must be OFF.Send Feedback
