Xilinx VC709 User Manual
Also see for VC709: User guideUser guideManualManualManual
                                                                                                    | |
Contents
| 
68 www.xilinx.com VC709 Evaluation BoardUG887 (v1.2.1) March 11, 2014Appendix A: Default Switch and Jumper SettingsConfiguration DIP Switch SW11See Figure 1-2, page 8 Item 29 for the location of SW11. Default settings are shown inFigure A-2 and details are listed in Table A-2.The default mode setting M[2:0] = 010 selects Master BPI configuration at boardpower-on.Default Jumper SettingsSee Figure 1-2, page 8 for locations of jumpers listed in Table A-3.X-Ref Target - Figure A-2Figure A-2: SW11 Default SettingsTable A-2: SW11 Default Switch SettingsPosition Function Default1 FLASH_A25 A25 Off2 FLASH_A24 A24 Off3 FPGA_M2 M0 Off4 FPGA_M1 M1 On5 FPGA_M0 M3 OffUG887_aA_02_0830121OFF Position = 0ON Position = 12 3 4 5A25A24M2M1M0Table A-3: Default Jumper SettingsJumper Function Default JumperPositionJ9 XADC GND ferrite filter bypass jumper NoneJ10 XADC GND-to-XADC_AGND jumper 1-2J42 XADC external 1.2V or internal VREFP selector 1-2J43 XADC VCC select header 2-3J53 XADC VCC5V0-to-XADC_VCC5V0 jumper 1-2J54 XADC REF3012 U35 VIN select 1-2J49 PCIe bus width select header 1-2J11 TI controller U42 Addr 52 Reset jumper NoneJ12 TI controller U43 Addr 53 Reset jumper NoneJ50 TI controller U64 Addr 54 Reset jumper None |
Related manuals for Xilinx VC709
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine