ZCU106 Board User Guide 22UG1244 (v1.0) March 28, 2018 www.xilinx.comChapter 2: Board Setup and ConfigurationQuad SPITo boot from the dual Quad SPI nonvolatile configuration memory:1. Store a valid Zynq UltraScale+ MPSoC boot image in the Quad SPI flash devicesconnected to the MIO Quad SPI interface.2. Set the boot mode pins SW6 [3:0] PS_MODE[3:0] as indicated in Table 2-4 for QuadSPI32.3. Either power-cycle or press the power-on reset (POR) pushbutton. SW6 is callout 46 inFigure 2-1.SDTo boot from an SD card:1. Store a valid Zynq UltraScale+ MPSoC boot image file on to an SD card (plugged into SDsocket J100) connected to the MIO SD interface.2. Set the boot mode pins SW6 [3:0] PS_MODE[3:0] as indicated in Table 2-4 for SD.3. Either power-cycle or press the power-on reset (POR) pushbutton. SW6 is callout 46 inFigure 2-1.See the Zynq UltraScale+ MPSoC Technical Reference Manual (UG1085) [Ref 2] for moreinformation about Zynq UltraScale+ MPSoC configuration options.Send Feedback
