Xilinx Zynq-7000 Getting Started Manual

Also see for Zynq-7000: Quick start guide User guide Application note Design guide User guide

ZC702 and ZVIK Getting Started Guide www.xilinx.com 11UG926 (v6.0) December 17, 2013Default Jumper and Switch Settings° Random programmable region of interest (ROI) readout° Automatic exposure control (AEC)• Standard interchangeable 2 / 3 -inch, 8 mm C-mount lensDefault Jumper and Switch SettingsFigure 1-3 calls out the major features on the ZC702 board. See the ZC702 Evaluation Boardfor the Zynq-7000 XC7Z020 All Programmable SoC User Guide (UG850) [Ref 4] for moredetailed information about the ZC702 board.Default factory settings of jumpers and switches on the ZC702 board are highlighted inFigure 1-4. Default switch and jumper settings are listed in Table 1-1 and Table 1-2.X-Ref Target - Figure 1-3Figure 1-3: Feature Callout for the ZC702 BoardFMC1 LPCConnectorXilinx XADCHeaderUG926_c1_03_111913FMC2 LPCConnector8 User LEDsUser 2-Pole DIP SwitchZynq-7000 AP SoCPower Management System(Bottom and Top of Board)FPGA PROG PushbuttonI2C Real-time Clock (RTC)DDR3 ComponentMemory (1 GB)RGMII EthernetPHY Oscillator,25,000 MHzQuad SPI Flash Memory (1 Gb)SD Card Interface ConnectorConfiguration Mode Select SwitchSystem Clock, 200 MHz,2.5V LVDSI2C Bus SwitchPower On/Off Slide SwitchCAN Bus TransceiverHDMI Controller,HDMI Video ConnectorUSB JTAGModule with IntegratedUSB Micro-B ConnectorI2C Programmable UserClock 3.3V LVDSUser PushbuttonsActive HighEthernet StatusLEDsUSB-to-UART Bridge,USB Mini-B Connector2x6 Male HeaderPins I/O Driven fromI2C Expander U80USB 2.0 ULPITransceiver,USB Micro-BConnector10/100/1000 MHzEthernet PHY,RJ45 with Magnetics2x6 and 1x6PMOD I/O Header12V Power ConnectorPMBus Connector(Bottom of board)Send Feedback