4 www.xilinx.com ZC702 and ZVIK Getting Started GuideUG926 (v6.0) December 17, 201302/12/2013 3.0.1 Removed stray internal draft banner from the cover page, and from the first page ineach chapter and appendix.05/14/2013 4.0 Deleted “Key Features of the ZC702 Evaluation Board” section. The Base TRD KeyFeatures, page 27 were updated for the Programmable Logic (PL) to “OnePerformance Monitor”. The required binaries in Base TRD Hardware SetupRequirements, page 28 were updated to include “zynq-zc702-base-trd.dts“.Port “P1” was labelled in Figure 3-2. Figure 3-6 and Figure 3-7 were replaced toillustrate the QT-based GUI and minimized GUI mode. In Running the VideoDemonstration for 720p Video Resolution, page 38, the instructions were updated forrunning QT based GUI in 720p mode and running the UART Menu basedDemonstration Application in 720p mode.08/12/13 5.0DraftUpdated document for Vivado Design Suite 2013.2. Added Command Line Applicationblock to Figure 3-1. Updated binaries under Base TRD Hardware Setup Requirements.Updated commands under Running the Qt-Based GUI Application Demonstration,Running the UART Menu-Based Demonstration Application, and Running the VideoDemonstration for 720p Video Resolution. Updated Figure 3-9 and Figure 4-1.Updated Requirements to Get Started (modified steps 3 and 4 and deleted step 5).Updated Evaluating AMS steps 2 and 3.10/21/13 6.0DraftUpdated document for Vivado Design Suite 2013.3. Updated Figure 3-6, Figure 3-7,and Figure 3-9. Updated zynq> commands (changed sobel_qt to run_sobel.sh).Date Version RevisionSend Feedback