YASKAWA MOTOMAN-HP20 Instructions Manual

Contents

YASKAWA MOTOMAN-HP20 Instructions Manual Manual pdf 47 page image

9.2 Notes on Maintenance Procedures9-99.2.3 Grease Replenishment/Exchange for L-axis SpeedReducerFig. 25 L-axis Speed Reducer Diagram Grease Replenishment(Refer to "Fig. 25 L-axis Speed Reducer Diagram".)Replenish the grease in accordance with the following procedure:1. Posture the L-axis vertical to the ground.2. Remove the plug and the screw from grease exhaust port and grease inlet respec-tively.3. Install the grease zerk A-MT6X1 on the grease inlet. (The grease zerk A-MT6X1 isdelivered with the manipulator.)4. Inject the grease into the grease inlet using a grease gun.5. Move the L-axis for a few minutes to discharge the excess grease.6. Remove the grease zerk and reinstall the hexagon socket head cap screw M6 on thegrease inlet. Tighten the screw with a tightening torque of 5 N·m (0.51 kgf·m). ApplyThree Bond 1206C on the thread part of the screw.The exhaust port and the grease inlet are inverted in case of ceiling installation.If grease is injected with the plug on, the grease will go inside the motor and may damageit. Never fail to remove the plug before the grease injection.Grease type: Molywhite RE No.00Amount of grease: 30 cc(60 cc for the 1st supply)L-axis speed reducer(Hexagon socket head plug PT1/8)Grease inlet(Hexagon socket headcap screw M6)Grease exhaust portL-armNOTENOTE