YASKAWA j1000 Quick Start Manual

Also see for J1000 CIMR-JC series: Installation & start-up manual Installation & start-up manual CHEAT SHEET User guide Technical manual

Contents

18 TOEP C710606 27 J1000 Quick Start Guide5 Start Up5 Start Up Drive Setup ProcedureThe illustration below shows the basic setup procedure. Each step is explained more detailedon the following pages.Select Normal / Heavy DutySet/check the basic parameters:Connect the load, run the motor and check the operationFine tune and set application parameters if necessary.Final check the operation and verify the settings.Drive is ready to run the applicationIntstall and wire the drive as explained.Turn the power on.Initialize the drive if necessary using parameter A1-01.START* b1-01, b1-02 for frequency reference and RUN command source* H1-, H2-, H3-, H4-, to configure the I/Os* Frequency reference values* C1-, C2- for Acceleration/Deceleration times and S-curves* E1-, E2- V/f pattern and motor dataRun the motor without load, check the operation and verify, if theupper controller (e.g. PLC,...) commands to the drive work asdesired.