![YOYOMOTION YOYOCam G3 User Manual Manual pdf 16 page image](https://manuals-archive2.s3.amazonaws.com/4788403/9fb218a0ec90bde751198b66964a625016f.jpg)
YOYOCam G3 User Guide v0.2 Page 16STEP 4 – Refine YOYOCam G3 SettingsHere are some of the settings that you may like to change in order to configure YOYOCam to yourneeds.Optimize image settingsBy default, YOYOCam takes five images at an interval of 0.5 seconds between each shot. The imagesize is 320 x 240 pixels. You may wish to have fewer images at higher resolution, e.g.2 images at 640x 480 pixels. (2 images is the maximum at this resolution).Command: #33#2#Response: Number of Alarm images has been set to 2Command: #32#3#Response: Image size has been reset to 3 (Size 3 = 640 x 480 pixels)For more information, see Image settings.Configure the sensors which detect an alarm conditionBy default, YOYOCam detects movement using the infrared body sensor. Camera movementdetection is also available.Infrared Body Sensor:Turn On: #118#1# (Default)Response: Infrared sensor - enabledTurn Off: #118#0#Response: Infrared sensor – disabledCamera Motion Detection:Turn On: #22#1#Response: Motion detection - enabledTurn Off: #22#0# (Default)Response: Motion detection – disabledFor more information, see Sensor Settings.Configure how YOYOCam signals alarmsBy default, YOYOCam sends SMS and MMS to the Master when an alarm is triggered. You can alsosend alarms by E-mail and voice calling. Additionally, YOYOCam can be set to bleep when the alarmis triggered. For more information, see Alarm Settings.The Status Indicator also blinks rapidly while sending the alarm messages. Send #143#0# to disableit.