YOYOCam G3 User Guide v0.2 Page 46Using the Remote ControlPairing your YOYOCam with a Remote ControlThe supplied Remote Controls are individually paired with YOYOCam at delivery. They can be pairedmanually e.g.after a factory reset of YOYOCam or to use one Remote Control for severalYOYOCams. Up to five remotes can be used with each YOYOCam; two are supplied.To pair a Remote Control with YOYOCam:1. Ensure that YOYOCam is on the GSM network during this procedure: Status Indicator or1. Make a short (less than one second) press and release of the RESET key. YOYOCam bleepsand the Status Indicator LED flashes orange indicating pairing mode.2. Press any button on the remote control. YOYOCam bleeps and LED turns green for 2seconds then returns to orange flashing ready to pair another remote control.3. Press RESET to exit pairing mode. In any case pairing mode times out after 15 seconds.Note: If the battery in the remote control is low, YOYOCam emits three bleeps and exits learningmode. Replace the battery in the remote control and try again.To un-pair all Remote Controls:Command: #111#Response: All remote controls have been deletedArming and Disarming YOYOCamPress to arm YOYOCam. The Status indicator flashes twice a second to indicate thatYOYOCam will arm itself after 20 seconds. The Status indicator shows when armed.Press to disarm YOYOCam. The Status indicator shows when disarmed.Note: If required, YOYOCam can send an SMS notification to the Master when a remote is used toarm or disarm YOYOCam. See SMS Notification when alarm is activated or deactivated by a remotecontrol in Advanced Settings.Emergency ButtonWhen the Emergency button is pressed, YOYOCam acknowledges with a bleep. By default,YOYOCam calls the Master number. When the Master answers, the audio from YOYOCam can beheard. If the Master does not answer, YOYOCam will call twice more (total three attempts) beforegiving up.