Yaesu FT-2000D - MENU MODE LIST Manual

Also see for FT-2000D: Brochure & specs Operating manual Update Update Update

Contents

Yaesu FT-2000D - MENU MODE LIST Manual Manual pdf 11 page image

Page 122 FT-2000D O PERATING M ANUAL063 A1A FRQDISPFunction: Selects the frequency Display Format for theCW mode.Available Values: dir / OFStDefault Setting: OFStdir (Direct Frequency): Displays the receiver carrierfrequency, without any offsetadded. When changingmodes between SSB and CW,the frequency display re-mains constant.OFSt (Pitch Offset): This frequency display re-flects the added BFO offset.064 A1A PC KYNGFunction: Enables/disables CW keying from the“PACKET PTT” terminal (pin 3) on the rear panel’sPACKET jack while operating on the CW mode.Available Values: EnA (Enable) / diS (Disable)Default Setting: diS (Disable)065 A1A QSKTIMEFunction: Selects the time delay between when the PTTis keyed and the carrier is transmitted during QSK opera-tion when using the internal keyer.Available Values: 15 / 20 / 25 / 30 msecDefault Setting: 15 msecMODE-DAT GROUP066 dAtA DATA INFunction: Selects the data input path to be used on thePKT mode.Available Values: dAtA / PCDefault Setting: dAtAdAtA:Uses the data input line connected to pin 1 ofthe PACKET jack while using the PKT mode.PC: This parameter is for future expansion of thistransceiver’s capabilities, but at this time is notsupported.067 dAtA DT GAINFunction: Sets the data input level from the TNC to theAFSK modulator.Available Values: 0 ~ 100Default Setting: 50068 dAtA DT OUTFunction: Selects the receiver to be connected to the dataoutput port (pin 4) of the PACKET jack.Available Values: nAin (Main) / SubDefault Setting: nAin (Main)069 dAtA OUT LVLFunction: Sets the AFSK data output level at the outputport (pin 4) of the PACKET jack.Available Values: 0 ~ 100Default Setting: 50070 dAtA VOX DLYFunction: Adjusts the “VOX” delay (receiver recovery)time on the PKT mode.Available Values: 30 ~ 3000 msecDefault Setting: 300 msec071 dAtA V GAINFunction: Adjusts the “VOX” gain on the PKT mode.Available Values: 0 ~ 100Default Setting: 50072 dAtA PKTDISPFunction: Sets the packet frequency display offset.Available: –3000 ~ +3000 Hz (10 Hz/step)Default: 0 Hz073 dAtA PKT SFTFunction: Sets the carrier point during the SSB packetoperation.Available: –3000 ~ +3000 Hz (10 Hz/step)Default: 1000 Hz (typical center frequency for PSK31,etc.)MODE-CW GROUPMENU M ODE