Page 77FT-2000D O PERATING M ANUALVOICE M EMORY (SSB/AM/FM M ODES)TRANSMITTER CONVENIENCE F EATURESVoice Memory Operation from the optional FH-2 Remote Control KeypadYou may also utilize the Voice Memory capability of the FT-2000D from the optional FH-2 Remote Control Keypadwhich plugs into the rear panel’s REM jack.When using the FH-2 Remote Control Keypad, you may record five memories with up to 20 seconds of voice audio each.LOCKOFFONLOCKOFFONLOCKOFFONLOCKOFFONRecording Your Own Voice in Memory1. Select the LSB, USB, AM, or FM mode using the frontpanel [MODE] selector buttons.2. Press the [MEM] key on the FH-2.3. Press any of the FH-2’s keys numbered [1] through[5] to select that memory storage register. If you donot press the PTT key (see next step) within five sec-onds, the memory storage process will be cancelled.4. Press the microphone’s PTT switch momentarily, the“ ” icon will glow steadily, and recording willbegin.5. Speak into the microphone in a normal voice level torecord the message (such as “CQ DX, CQ DX, this isW 6 Delta X-Ray Charlie, W 6 Delta X-Ray Charlie,Over”). Remember that the time limit for recordingany message is 20 seconds.6. Press the FH-2’s [MEM] key to terminate the messagestorage process.Checking Your Recording1. Be sure that the front panel [MOX] and [VOX] but-tons are both “Off” (the LED imbedded in the buttonmust be off).2. Press the FH-2’s [1] ~ [5] key (whichever one you justrecorded in), and you will hear the contents of the voicememory you just recorded.A DVICE:You may adjust the playback level of the recording viaMenu item “016 dUS RX LVL.”Transmitting the Recorded Message1. Select the LSB, USB, AM, or FM mode using the frontpanel [MODE] selector buttons.2. Press the front panel’s [BK-IN] button.3. Press the FH-2’s [1] ~ [5] key, depending on whichmemory register’s message you wish to transmit. If youhit the key again during playback, the message will beterminated.LOCKOFFONA DVICE:You may adjust the transmit (audio) level of the recordingvia Menu item “017 dUS TX LVL.”