Yaesu FT-4XR Operating Manual

Also see for FT-4XE: Operating manual Operating manual Advance manual Information for Customers Operating

21Memory Channel ScanningThe receiver may be set to scan memory channels:1. While operating in the VFO mode, press the [ V/M] key to enter theMemory mode.2. Press and hold the [▲] key or [▼] key.Scanning starts of the memory channels begins.If the scanner halts on an incoming signal, the back light will turn ON andthe decimal point between the “MHz” and “kHz” digits of the frequencydisplay will blink.3. Press the Function key to cancel the scanning.Setting the Receive Operation When Scanning StopsPress and holdthe Function key → Press the  or  key → Press the Function key(Confirms the setting)(Enters the Set mode) (Select Set Mode "34 SCN.RSM")1. Press the [▲] key or [▼] key to select the operation that is to beperformed after the scan stops:Display DescriptionBUSY(Default setting)In BUSY mode, the scanner will halt on a signal itencounters. Scanning will resume two seconds afterthe other station signal ceases transmitting. In thecase of constant-carrier signals like Weather Stationbroadcasts, the scanner will likely remain on thisfrequency indefinitely.HOLDIn HOLD mode, the scanner will halt on a signal itencounters. Scanning will only resume when it ismanually re-initiated.TIMEIn TIME mode, the scanner will halt on a signal itencounters, scanning will resume after five secondseven if a signal is still on the frequency.2. Press the PTT switch to save the setting and exit to normal operation.The above Set Mode “34 SCN.RSM” operation is common for all scanningoperation.