Yaesu VX-8GE Operating Manual

VX-8GE OPERATING MANUAL38CTCSS/DCS/EPCS OPERATIONPROGRAMMING THE USER MELODYThree User Beep Memories are provided, allowing you to create unique original beeptone melodies.Each User Beep Memory can store up to 64 steps with three octaves (“C1” through “B3”).1. Press and hold the m key for one second to enter the Set Mode.2. Rotate the DIAL knob to select Set Mode Item 10: BEEPMELODY.3. Press the m key briefly to enable adjustment of this SetMode Item.4. Rotate the DIAL knob to select the memory slot into whichyou wish to store your programmed beep melody. Avail-able selections are 1, 2, and 3. The previously stored beepmelody will be displayed.5. Press the M key to enable programming the beep melody.Press and hold the h key for one second to clear anyprevious beep melody, if desired.6. Rotate the DIAL knob to select the first beep tone of theUser Beep Melody. Available selections are C1 - B3, andPOS (rest).7. Press the M key, then rotate the DIAL knob to set thelength of the first beep tone. Available selections are 10ms(10 msec) - 2500ms (2.5 sec).8. Press the M key to accept the first beep tone of the UserBeep Melody.9. If you make a mistake, press the B key to back-spacethe cursor, then re-enter the correct beep tone or length.10. Repeat steps 6 - 9 until you have completed the User BeepMelody.11. When there is a beep tone, which you wish to delete, bringthe cursor to that beep tone using the B/M key, thenpress the c key repeatedly until the “SELECT” notationin the “Operation Mode” slot turns into “DELETE”. Now,press and hold in the c key for one second to delete that beep tone.CTCSS/DCS/EPCS BELL OPERATIONC2C1 C3D2D1 D3E2E1 E3F2F1 F3G2G1 G3A2A1 A3B2B1 B3Step Operation ModeMemory Slot Tone LengthBeep Tone